BENTONITE MODIFIED WITH METAL SALTS FOR ENHANCED ADSORPTION OF Cu²⁺, PO₄³⁻ AND OIL POLLUTANTS IN WASTEWATER TREATMENT
Keywords:
bentonite; montmorillonite, clay enrichment, acid activation, metal oxide modification, adsorption, heavy metals; copper removal, phosphate removal, wastewater treatment; BET surface area, X-ray diffraction; petroleum sorptionAbstract
This study investigates the structural, textural, and adsorption properties of two bentonite clays (B1, Na-smectite; B2, Ca/Mg-smectite) from Uzbekistan, subjected to sequential enrichment and surface modification with metal (hydr)oxide coatings. Enrichment via decantation and 10% H₂SO₄ treatment increased montmorillonite content, raised BET specific surface area from 56–77 m²/g, and reduced mean pore radius to 3.6–4.0 nm. Modification at pH 9–11 with two salt mixtures — Fe³⁺/Mg²⁺/Mn²⁺ (FB series) and Ca²⁺/Zn²⁺/Mn²⁺ (KB series) — followed by thermal stabilization at 300 °C further elevated surface area to 95–146 m²/g and total pore volume to 0.305–0.354 cm³/g. X-ray diffraction confirmed intercalation and formation of iron oxide (hematite, magnetite) phases. Maximum adsorption capacities were 128.5 mg/g for Cu²⁺ and 153.3 mg/g for PO₄³⁻ at neutral pH, with adsorption efficiency strongly pH-dependent (optimal range 2–10). Adsorption of water vapor favored KB composites, whereas benzene vapor adsorption favored FB composites, reflecting contrasting surface hydrophilicity. Modified bentonites reduced petroleum contaminants by >80% and, when combined with H₂O₂, achieved ~99% oxidative removal of oils and fats within 20–25 min. These results demonstrate the superior environmental remediation potential of metal (hydr)oxide-coated bentonites for multi-contaminant wastewater treatment.